Agriculture

Protocol for Monitoring Diamondback Moth with Pheromone-Baited Traps

Purpose of Monitoring the Adult Stage

Diamondback moths (Plutella xylostella) can be serious pests of canola and cruciferous vegetables. It is the larval stage that is damaging to the plants, however the adult stage appears before the larvae are present. Monitoring the adult moths provides an opportunity to assess in advance the potential for high levels of larvae, provided natural controls are not sufficient.

The pheromones used by female diamondback moths to attract male moths are known and are synthesized for use in monitoring programs. These synthetic pheromone lures are very effective at attracting male moths to traps, which have been designed to capture the moths. Use of these traps provides a relatively simple method of detecting an influx of the moth in advance of the damaging larval stage of diamondback moth. This gives farmers, agronomists, chemical dealers, and others involved in pest management some advanced warning of potentially damaging levels of larvae, and enables them to place proper emphasis on monitoring for the larvae.

This monitoring program helps predict risk on a regional, but not field specific basis. At no time should a decision to use insecticides to control diamondback moth be made based only on information from the traps for adults of this insect. Such decisions need to be made after later sampling for the damaging (larval) stages of diamondback moth and determining if the levels of larvae present in the field are above the threshold. Weather can affect the success of mating and laying eggs, and many mortality factors could reduce the numbers of eggs and larvae before they develop to the damaging stage.

When To Monitor

Diamondback moth do not overwinter in the Canadian prairies in significant numbers, but high populations may be blown in on winds from the south. They are at a higher risk of being a problem in years when high populations blow in and establish early (May or early June). Thus the primary goal of this monitoring program is to determine when diamondback moth populations arrive, and in what number. This, combined with considering what the environmental conditions are like when they arrive, will determine the risk of them being a significant problem.

Diamondback moth traps should be placed in fields during the last week in April, or as close to this date as possible. This may be before fields are even seeded. First moth counts should be made the following week.

Traps for diamondback moth can be placed in fields regardless of whether canola has, or will be, seeded into the field. Having traps near fields that are or will be seeded to canola is ideal, but it is more important to place the traps at the proper time than to wait and see where canola is seeded.  

Assembling The Traps

1. Fold open the trap so it is tent shaped (Figure 1).

2. Insert the pin through the middle of one side of the trap roof (Figure 2).

3. Pin the rubber lure so the pin extends through the narrow top of the lure (Figure 3). The rubber stopper containing the pheromone should hang from the top of the trap. Do not handle the lures with your bare hands. Wear rubber or latex gloves or use tweezers to handle the lures. Store lures below 0C when they are not in the trap.

4. Remove the covering from the sticky inset, and place it on the bottom of the trap so the sticky surface faces up (Figure 4). 

5. Press in the front and back flaps until they clip into the slits in the sides of the trap. This secures the sticky bottom in place.

6. A T-shaped bar can be inserted into a hollow metal pole, which is hammered into the ground, so there is a horizontal surface to hang the trap from. Or a bent piece of rebar, or other horizontal surface, can be used to suspend the traps from. Alternatively, a hooked stake can be used to suspend the trap (Figure 5).

6. The wire that extends from the top of the trap can be wrapped around a stake or one of the horizontal ends of a T-shaped bar to secure the trap in place.
                      
Figure 1. Trap components: Delta trap, Insert, map pin, and lure.         Figure 2. Pin inserted.

 
          
Figure 3. Lure containing the pheromone placed in trap.      Figure 4. Sticky insert placed in trap.

      Completed trap set-up              
             Figure 5. Completed trap set-up, show 2 methods of securing trap. 

Trap Height

Place the traps 50 cm above ground level or at canopy height.

Checking Traps

If there are only a few diamondback moths on the insert when they are checked, these moths can be removed from the sticky surface with tweezers and the insert reused. If the insert is heavily covered with insects or dirt the sticky surface will not retain moths for future monitoring and should be replaced with a new insert. 

Length Of Trapping Period

Traps should be checked and the number of diamondback moths counted once a week over a six-week period. The pheromone lures for diamondback moth will remain attractive for the full trapping period and does not need to be replaced.

Diamondback Moth in trap

For further information on monitoring diamondback moth please contact:

John Gavloski
Entomologist
Manitoba Agriculture
Box 1149, Carman, Manitoba R0G OJO
Phone: 204-745-5668 (office); 204-750-0594 (cell)